        How to make a proccesor stop on your ST/STE

It's really a simple thing to do, you'll only need two wires and a switch.

On the ST you should connect the wires to pin 16(Ground) & 17(Halt) on the
processor.
Connect the wires to the switch and that's it.

If you own an STE you might have found out that Atari is using a new kind
of processor-chip. It's a 68 pin-chip instead of the ordinary 64 pin-chip.
When you open your STE you'll have three 68 pin-chip and probably there are
metal-clips on two of them. The processor is the one on the right. The pins
you should use is 17(Ground) & 19(Halt). 


Remember that i won't take any responsibility if your computer breaks 
down or anything like that. If you want a processor-stop you'll do it
on your own responsibilty. 

I have done it myself on both STs & STEs and it works fine and i haven't
succeeded in damaging them. 




I'm apologize my bad english coz I rather code than doing my homework.

Dr.Stein/The X'press Crew

