                       RS232 Configuration program  21 Jan 1995


	Having recently obtained Ghostlink, an excellent utility which allows
you to link a PC to your Atari and use the PC as a slave, I found that the ST
was not defaulting to a baud rate which was compatible. I found that the rate
19200 gave the best result. So I needed a program, just a simple one, to give
me the opportunity of changing the RS232 configuration. Here is the result.

	Actually this only sets the flow control off (default anyway) and the
baud rate to 19200 unless you select otherwise.  The program should be placed
in an AUTO folder.  By pressing either the left or right shift key whilst the
program loads and runs you can select a rate to use. Just letting the program
run will result in 19200 being used.

	If there is demand  (I somehow doubt it!)  and perhaps with financial 
reward (doubt increases!) I may change the program so that you can change the
default value.

	Have fun. Contact me (PC swaps, ST swaps, etc)...
	
	Martin Cubitt, 14 Deepdene Avenue, Rayleigh, Essex SS6 9LG    England